![]() So my tuner have last IC and it's not supported by any U-Boot versions, provided by vendor. Spansion S25FL016A (2MB) with JEDEC ID: 0x010214 (This flash chip is not supported by U-Boot).Atmel AT25DF161 (2MB) with JEDEC ID: 0x1F4602 (This flash chip support added in U-Boot of AMIKO_ALIEN2_1.2.51_E2_Boot_Upgrade.rar firmware).Spansion S25FL016K (2MB) with JEDEC ID: 0圎F4015 (This flash chip is originally supported by U-Boot). ![]() Here is list of SPI-flash chips, used in this tuner: So, before I set "Boot To E2", the bootloader's environment variables area (0x0a0000.0x0c0000) was totally clean, and now it have env data, but bootloader ignoring it, and fails.Īfter studying U-Boot sources I found that Amiko's manufacture changed Flash-IC, It was at the 2nd-time, since they started selling that device! SPI: ERROR: Unknown SPI Device detected, devid = 0x01, 0x02, 0x14ĮRROR: Offset out of range (max=0xffffffff) NAND: Bad block table found at page 262080, version 0x01īad block table found at page 262016, version 0x01 The message that I see after I choose "Boot To E2" in "Reset To Factory Defaults" menu saying this: I able to boot only SPARK image, and even if I choose boot from enigma that i wrote to flash - tuner can't boot to it.Īuthor is not liable for any damage caused to the equipment during the following this how-to, do it on your own risk! But unfortunaly there was a problem with flash IC and bootloader. ![]() After Amiko Alien2 bought, I tried to install AR-P image of Enigma2/PLI. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |